KZ SERIES - Deep Centrifugal Jet

Genvik Deep well Jet Centrifugal Pumpsets volute Chamber and impellers are designed to give the best possible hydraulic efficiency and suction lift characteristics. Motor stator is made of low watt loss ferro silicon steel laminations. The winding are of high grade enameled copper wire and are varnish impregnated. Construction of motor frame and usage of quality materials reult in high performance and low temperature raise, thereby increasing the life cycle of the motor.

Genvik Deep well Jet Centrifugal pumpsets are available in twin type and packer type versions. Twin type is suitable for borewells with a diameter of 75mm (3”) and above. in twin type jet Pumpsets there are two pipes viz. suction pipe and pressure pipe wich connects the jet assembly to the pump. Pressurized water flows through the pressure pipe to the nozzle from the pump casing. Water sucked through the foot valve and the Water passing through the nozzle mix together and flow of tube well does the function of pressure pipe, i.e. Pressurized water flows through the tube well casing and enters the nozzle. Hence one pipe is eliminated.

Applications

Domestic Farms
Gardens
Civil applications

FEATURESSPECIFICATIONSMATERIAL OF CONSTRUCTIONCATALOGQUOTE

Good suction lift characteristics
High operating efficiency resulting in lower power consumption
Inbuilt thermal over load protector
The pumpset can be installed both in horizontal and vertical position
Available in CI, Bronze and Noryl Impellers
Available in Aluminium & CI Frame motor body

AJ & BP Series

Power Range	0.37 kW(1HP) – 1.5 kW (0.5HP – 2HP)
Speed	2880 RPM
Version	Single phase 220 – 240V; Three phase 380 – 415V, 50HZ AC S
Maximum suction lift/head	92 metre
Maximum flow rate	50 lpm (3m³/hr)

PUMPSET

Pump Casing	Cast Iron
Bracket / Rear Cover	Cast Iron
Impeller	Cast Iron / Bronze / Noryl
Shaft	SSS 410

Click here to view

"*" indicates required fields

Name*

Email*

Phone*

City*

Country*

Subject*

Your Message*

Hidden

Source

CAPTCHA

This field is for validation purposes and should be left unchanged.