Horizontal & Vertical Openwell Pumps

GENVIK Openwell Submersible Pumpsets are ideally suitable for openwells or tanks where a wide fluctuation of water level occur. This works under water and rests at the bottom of the well. Prime mover is rewindable, water-cooled motor. Specially designed water lubricated bearings are used to withstand the axial thrust loads with minimum wear and tear. The stator is wound with special waterproof synthetic film insulated copper winding wires and made up of low watt loss silicon steel laminations assembled under pressure and rigidly locked. Motor sealing is made by polymers, 'O' rings, oil seals and sand guard to avoid ingress of well water/salt into the motor. Pressure equalizing rubber diaphragm is provided to guard the motor from pressure and volume variation of water as detailed in our operator's manual. Three phase motor requires an adequate motor protection control panel.

Applications

Agriculture
Domestic
Irrigation
Gardens
Industrial
Rural Water Supply

FEATURESMATERIAL OF CONSTRUCTIONCATALOGQUOTE

No suction and priming problem
Noiseless operation
High operating efficiency
Extremely tough and hard wearing lubricated journal bearings are used
Can be easily dismantled and repaired
Dynamically balanced rotating parts ensures minimum vibration and longer life
Designed for wide voltage fluctuations

PUMPSET

Part Name	Material
Motor Body	Cast Iron
Impeller	Cast Iron
Casing	Cast Iron
Rear cover	Cast Iron
shaft	SS 410
Front Bracket	Cast Iron with ss Thrust Bearing
Thrust Assembly	carbon
Rotor	Copper / Aluminium

Click here to view

"*" indicates required fields

Name*

Email*

Phone*

City*

Country*

Subject*

Your Message*

Hidden

Source

CAPTCHA

This field is for validation purposes and should be left unchanged.